The J46 engine was developed as a larger, more powerful version of Westinghouse's J34 engine, about 50% larger. The Westinghouse model number was a continuation of the "X24C" series of the J34. The model number assigned was X24C10, even though the J46 differed in many design features from the smaller J34. It was seen as a lower development risk than the Westinghouse J40 which was in parallel development at the same time. The development program ran into many problems with this engine, including the original electronic control system, compressor/turbine mismatches, combustion instability and control issues at altitude leading to compressor stalling The produced -8, -8A and -8B engines were all derated from the original design specification on both thrust and specific fuel consumption. The engine featured a 12-stage compressor that was driven by two turbine stages on a single shaft. Early development engines also featured an afterburner which was a simple "eyelid" design that was actuated by long control rods that ran the length of the engine. By the time the engine reached production, the nozzle design had been changed to an iris-type "petal" design activated by the same long control rods now attached to a ring that ran on rollers. Pulling or pushing on the rods moved the ring back and forth with the iris opening or closing. The original design using the electronic control system would have featured a fully controllable A/B thrust from minimum to maximum, but this was abandoned when the electronic control could not be brought to acceptable levels of reliability. The final A/B was an "ON/OFF" unit.
Variants
;J46-WE-2: ;J46-WE-3: 3,980 lbf thrust Was to be used the Douglas X-3 Stiletto. Failed to exit testing due to thrust shortfalls. ;J46-WE-4/-10: 3,980 lbf thrust The non-A/B version of the J46-WE-2/-8B. Intended for the Douglas F3D-3 SkyKnight but did not go into production because of schedule slippage and the F3D-3 cancellation. ;J46-WE-8: ;J46-WE-8A:This variant powered the F7U-3 Cutlass and produced 5,500/5,800 lbf of A/B thrust. All -8A engines were upgraded to the -8B build standard after being produced. ;J46-WE-8B:The F7U-3 was equipped with two J46-WE-8B turbojets giving a 680 mph max speed. This variant also powered the Harvey Hustler, a speed boat designed to go faster than 275 mph. ;J46-WE-8: 3,980 lbf This variant powered both the F7U-3 and F7U-3M, the missile-capable Cutlass. ;J46-WE-12:This variant powered the F2Y Sea Dart hydroski aircraft. Basically identical to the -8/-8B, the aircraft was equipped with a fresh water spray system that flushed salt deposits out of the engine before takeoff and after shutdown. ;J46-WE-18:This variant produced an increased 6,100 lbf of A/B thrust for the proposed A2U-1 attack aircraft, an attack variant of the F7U. This variant was canceled with the aircraft program.
Smithsonian National Air and Space Museum, Exhibit 1971-0911, J46-WE-8B, Serial WE405773, 15 total running hours, including acceptance testing and 3 flights in an F7U-3. In storage.
Green Mamba dragster owned by Doug Rose in Tampa, Florida
No -1, -2, -3, -5, -12 or -18 engines are known to exist
