For 2001, Suzuki introduced a new GSX-R model that replaced the largest and most powerful model of the GSX-R series sport bike, the GSX-R1100, with the all new GSX-R1000. As the model name revealed, the engine's cylinder displacement was roughly, about 100 cc smaller than its predecessor. The GSX-R1000 was not just an enlarged version of the GSX-R750, although it shared many features with its little brother. The main frame is the same in both models, but the material used on the big brother was thicker. Suzuki claimed the torsional rigidity of the frame had increased 10% in comparison with the GSX-R750. The GSX-R1000 engine was a redesigned GSX-R750 engine. The R1000 had a bigger bore and longer stroke, newly designed pistons with lower crown, and gear-driven counter balancer. The engine weighed which was slightly heavier than the 750 engine but lighter than the engine of the GSX1300R. The performance of the engine is a peak of at 9,500 rpm, as measured on the crank and, when measured on the rear wheel with small variations between different instances of the same model. The redline is set at 12,000 rpm. The maximum torque of the engine is at 8,000 rpm. Combined with a total weight of this gives the GSX-R1000 a top speed of, a 1/4 mile time of 10.1 seconds at, and a 0 to time of 3 seconds. Using titanium for the exhaust down pipe and the inside of the silencer, enabled the 1000s exhaust system to become lighter than that of the 750. Titanium was also used in the front fork to coat the stanchions. An exhaust tuning valve had been mounted inside the exhaust pipe. Using a servo the system dynamically adjusted the exhaust back pressure, according to engine speed, throttle position, and gear selection for increased torque, lower emissions, and decreased noise—the exhaust noise of the GSX-R1000 is notably lower than that of the GSX-R600. With the 2001 model of the GSX-R1000, the 1998 Yamaha YZF-R1 was finally surpassed with the GSX-R being lighter and more powerful. The 2001 model carried over to 2002 with minimal changes. 2002 introduced i.a. modifications to the fuel pump, clutch, front axle, torque link, mirrors, and luggage hooks. The manual fast-idle was replaced with a computer operated implementation. New colours, and new GSXR stickers.
2003 (K3, K4)
After the GSX-R1000 had been three years on the roads and race tracks, Suzuki put out a new version of the model in late September 2002. Suzuki engineers had been working on the three things that made a fast bike faster; weight, power and handling. The 2003 year's GSX-R1000 was improved in all three counts. It weighed less, had more power/torque and handled better. The physical dimensions of the bike were almost identical with the previous year's model. The seat height and the overall height were somewhat lower but the geometry of the bike was exactly the same as before. The already rigid aluminum alloy frame was newly designed and enforced with internal ribs, also there was an updated headlight and tail fairing. The frame as well as the wheels were now coated black. The front brakes were also new. Suzuki decided to drop the six-piston calipers. The new radially mounted four-piston calipers weigh 30 grams less and grip smaller discs that save another. Though smaller, Suzuki claimed that the new brakes provide better stopping and turn-in performance. The headlights of the 2003 year's GSX-R1000 were mounted vertically to enable the ram-air intakes in the front to be placed nearer the bike's center line. The new design was very much inspired by the look of the Hayabusa. The instruments were also redesigned. The cylinder displacement of the engine remained the same, but more power/torque and better throttle response had been achieved by adding four ventilation holes between the cylinders to equalize crankcase pressure beneath the pistons, moving the air intake nearer to the centerline and upgrading the engine management system from a 16-bit to a 32-bit ECU. The entire exhaust system was now made of titanium to save an additional and the tail light was replaced with LEDs. The 2003 model carried over to 2004 without any significant improvements.
2005 (K5, K6)
The 2005 model year GSX-R1000 had a redesigned engine and chassis. It had lower weight than the previous model and the engine had an larger piston displacement. It had a totally new frame reducing the total length of the bike by but reducing its wheelbase only. There were new brakes with radial mounted calipers and discs at the front. The new titanium silencer was said to be designed to reduce turbulence to minimum. This model weighs in at a mere 365 lbs dry, putting it towards the top of the power-to-weight ratio charts. This weight reduction came at a cost of durability issues with the 2005-2006 models experiencing frame cracking. The 2005 model has a tested wet weight of. Power output is tested at and peak torque is both at the rear wheel. Also in 2005 Suzuki used a single "S" logo on the tank on all models instead of The brand's full name The 2005 model carried over to 2006 without any significant improvements other than a few appearance changes. The 2006 model had a measured top speed of.
2007 (K7, K8)
On September 22, 2006, Suzuki revealed a significantly updated GSX-R1000 for 2007 at the Paris motor show. The new bike gained over the 2006 model which was due to its new exhaust system and new emissions regulations. To counter this weight increase, Suzuki claimed improved aerodynamics along with a faster revving engine and larger throttle body. Although not a completely new model, the engine and chassis have been updated. It also featured three different engine mapping configurations, selectable via two buttons located on the right handlebar. One up, and one down arrow to cycle between Mode A, Mode B, and Mode C. It also received a hydraulic clutch. The 2007 model carried over to 2008 without any significant improvements.
2017 (L7)
The 2017 model, introduced to reporters at EICMA in late 2016, had a significantly redesigned engine the first since the last engine update on the 2009 model. This new engine has a higher RPM limit and no balancer shaft to quell vibration, also a mechanical variable valve timing used for ten years by Suzuki in MotoGP and drive by wire throttle. This model is the first to get the addition of traction control with a inertial measuring unit measuring yaw, roll and pitch also all lighting is now LED. Another first for any GSX-R is the use of a fuel gauge on this model. Along with the new 2017 GSX-R1000 model, Suzuki has also released an up spec model GSX-R1000R; this R model comes with a Motion Track Brake System, Bi-directional quick shifter and launch control. Also on the R model, as reported by Sport Rider, are the same Showa Balance Free Front fork and Balance Free Rear Cushion shock that come standard on the 2016 Kawasaki ZX-10R. Specifications are 202 horsepower at 13,200 rpm, 157.2, 86 lb-ft torque at 10,000 rpm and ; 76.0 mm x 55.1 mm bore x stroke, and 13.2:1 compression ratio.