Quadruple glazing is a type of insulated glazing comprising four glass panes, commonly equipped with low emissivity coating and insulating gas in the cavities between the glass panes. Quadruple glazing is a subset of multipane glazing systems. Multipane glazing with up to six panes is commercially available. Multipane glazing improves comfort, reduces recurring expense and can reduce greenhouse gas emissions by minimising heating and cooling demand. Different administrative districts mandate different energy efficiency level. Quadruple glazing may be required to achieve the desired energy efficiency levels in the arctic regions, or to allow for higher glazing ratios in curtain walling without increasing winter heat loss. Quadruple glazing allows building glazing elements to be designed free of modulated external sun-shading as variable solar gain no longer provides energy efficiency improvement at low thermal transmittance achievable with quadruple and other multipane glazing. There are numerous buildings built with ageing triple glazing in Nordic countries that are in need of renovation where multipane glazing is a solution of choice.
With quadruple glazing, the center of panel U-value of 0,33 W/ is readily achievable. With six-pane glazing Ug value as low as 0,24 W/ was reported. With U-value that low, new, not obvious options arise. Energy efficient buildings without variable sun shading. To save the cost, with overall window thermal transmittance lower than about 0,4 W/ it is possible to abandon, otherwise common, variable external shading. It has been shown that at such low window U-values, glazing with moderate solar gain performs comparably to glazing of comparable U-value with variable external shading and high solar gain. This is because with improved overall U-values building's heating demand diminishes and as a consequence solar heat gain loses much of its utility. Nearly zero-heating buildings. Already in 1995, it was predicted that with a glazing U-value of 0,3 W/ zero-heating buildings could be realized. It has also recently been shown that for glazed buildings with system U-values as low as 0,3 W/ the heating demand might be decreased to nearly zero. The remaining cooling demand can be favorably synchronized with solar radiation, where maximum photovoltaic generation nearly coincides with the maximum power needed for cooling. In this way, the building would not need a fossil winter power reserve and it would not need seasonal energy storage.
Multipane glazing engineering
Quadruple or multipane glazing is often designed with thinner intermediate glass panes to save weight. To prevent intermediate panes from thermal stress cracking it is sometimes required to use heat-strengthened glass. With more than three glass panes, special care must be taken of the spacer and sealant temperatures as intermediate glass panes in contact with these glazing elements can readily exceed design temperature limits of respective materials due to solar radiation heating. Solar irradiance heating of intermediate glass panes increases substantially with an increased number of glass panes. Multipane glazing must be carefully designed regarding the climatic loading which is higher with the increasing number of glass panes. Special measures for handling glass bulging effect, which occurs due to insulating gas heating and expanding, might be employed. Finite element analysis is often used to calculate appropriate glass sheets' strengths.
