Hydrogen–deuterium exchange


Hydrogen–deuterium exchange is a chemical reaction in which a covalently bonded hydrogen atom is replaced by a deuterium atom, or vice versa. It can be applied most easily to exchangeable protons and deuterons, where such a transformation occurs in the presence of a suitable deuterium source, without any catalyst. The use of acid, base or metal catalysts, coupled with conditions of increased temperature and pressure, can facilitate the exchange of non-exchangeable hydrogen atoms, so long as the substrate is robust to the conditions and reagents employed. This often results in perdeuteration: hydrogen-deuterium exchange of all non-exchangeable hydrogen atoms in a molecule.
An example of exchangeable protons which are commonly examined in this way are the protons of the amides in the backbone of a protein. The method gives information about the solvent accessibility of various parts of the molecule, and thus the tertiary structure of the protein. The theoretical framework for understanding hydrogen exchange in proteins was first described by Kaj Ulrik Linderstrøm-Lang and he was the first to apply H/D exchange to study proteins.

Exchange reaction

In protic solution exchangeable protons such as those in hydroxyl or amine group exchange protons with the solvent. If D2O is solvent, deuterons will be incorporated at these positions. The exchange reaction can be followed using a variety of methods. Since this exchange is an equilibrium reaction, the molar amount of deuterium should be high compared to the exchangeable protons of the substrate. For instance, deuterium is added to a protein in H2O by diluting the H2O solution with D2O. Usually exchange is performed at physiological pH where proteins are in their most native ensemble of conformational states.
The H/D exchange reaction can also be catalysed, by acid, base or metal catalysts such as platinum. For the backbone amide hydrogen atoms of proteins, the minimum exchange rate occurs at approximately pH 2.6, on average. By performing the exchange at neutral pH and then rapidly changing the pH, the exchange rates of the backbone amide hydrogens can be dramatically slowed, or quenched. The pH at which the reaction is quenched depends on the analysis method. For detection by NMR, the pH may be moved to around 4.0–4.5. For detection by mass spectrometry, the pH is dropped to the minimum of the exchange curve, pH 2.6. In the most basic experiment, the reaction is allowed to take place for a set time before it is quenched.
The deuteration pattern of a molecule that has undergone H/D exchange can be maintained in aprotic environments. However, some methods of deuteration analysis for molecules such as proteins, are performed in aqueous solution, which means that exchange will continue at a slow rate even after the reaction is quenched. Undesired deuterium-hydrogen exchange is referred to as back-exchange and various methods have been devised to correct for this.

Detection

H–D exchange was measured originally by the father of hydrogen exchange Kaj Ulrik Linderstrøm-Lang using density gradient tubes. In modern times, H–D exchange has primarily been monitored by the methods: NMR spectroscopy, mass spectrometry and neutron crystallography. Each of these methods have their advantages and drawbacks.

NMR spectroscopy

and deuterium nuclei are grossly different in their magnetic properties. Thus it is possible to distinguish between them by NMR spectroscopy. Deuterons will not be observed in a 1H NMR spectrum and conversely, protons will not be observed in a 2H NMR spectrum. Where small signals are observed in a 1H NMR spectrum of a highly deuterated sample, these are referred to as residual signals. They can be used to calculate the level of deuteration in a molecule. Analogous signals are not observed in 2H NMR spectra because of the low sensitivity of this technique compared to the 1H analysis. Deuterons typically exhibit very similar chemical shifts to their analogous protons. Analysis via 13C NMR spectroscopy is also possible: the different spin values of hydrogen and deuterium gives rise to different splitting multiplicities. NMR spectroscopy can be used to determine site-specific deuteration of molecules.
Another method uses HSQC spectra. Typically HSQC spectra are recorded at a series of timepoints while the hydrogen is exchanging with the deuterium. Since the HSQC experiment is specific for hydrogen, the signal will decay exponentially as the hydrogen exchanges. It is then possible to fit an exponential function to the data, and obtain the exchange constant. This method gives residue-specific information for all the residues in the protein simultaneously The major drawback is that it requires a prior assignment of the spectrum for the protein in question. This can be very labor-intensive, and usually limits the method to proteins smaller than 25 kDa. Because it takes minutes to hours to record a HSQC spectrum, amides that exchange quickly must be measured using other pulse sequences.

Mass spectrometry

Hydrogen–deuterium exchange mass spectrometry can determine the overall deuterium content of molecules which have undergone H/D exchange. Because of the sample preparation required, it is typically considered to provide an accurate measurement of non-exchangeable hydrogen atoms only. It can also involve H/D exchange in the gas phase or solution phase exchange prior to ionization. It has several advantages over NMR spectroscopy with respect to analysis of H–D exchange reactions: much less material is needed, the concentration of sample can be very low, the size limit is much greater, and data can usually be collected and interpreted much more quickly.
The deuterium nucleus is twice as heavy as the hydrogen nucleus because it contains a neutron as well as a proton. Thus a molecule that contains some deuterium will be heavier than one that contains all hydrogen. As a protein is increasingly deuterated, the molecular mass increases correspondingly. Detecting the change in the mass of a protein upon deuteration was made possible by modern protein mass spectrometry, first reported in 1991 by Katta and Chait.
Determining site specific deuteration via mass spectrometry is more complicated than using NMR spectroscopy. For example, the location and relative amount of deuterium exchange along the peptide backbone can be determined roughly by subjecting the protein to proteolysis after the exchange reaction has been quenched. Individual peptides are then analyzed for overall deuteration of each peptide fragment. Using this technique the resolution of deuterium exchange is determined by the size of the peptides produced during digestion. Pepsin, an acid protease, is commonly used for proteolysis, as the quench pH must be maintained during the proteolytic reaction. To minimize the back-exchange, proteolysis and subsequent mass spectrometry analysis must be done as quickly as possible. HPLC separation of the peptic digest is often carried out at low temperature just prior to electrospray mass spectrometry to minimize back-exchange. More recently, UPLC has been used due to its superior separation capabilities.
It was proposed in 1999 that it might be possible to achieve single-residue resolution by using collision-induced dissociation fragmentation of deuterated peptides in conjunction with tandem mass spectrometry. It was soon discovered that CID causes "scrambling" of the deuterium position within the peptides. However, fragmentation produced by MALDI in-source decay, electron capture dissociation, and electron transfer dissociation proceed with little or no scrambling under the correct experimental conditions. Scrambling of the isotopic labeling is caused by collisional heating prior to dissociation of the ion and while CID do cause scrambling, collisional heating can also occur during ionization and ion transport. However, by careful optimization of instrument parameters which cause ion heating, hydrogen scrambling can be minimized to a degree which preserves the solution phase isotopic labeling until fragmentation can be performed using a technique where scrambling does not occur. This suggests that eventually it may be possible to obtain single-residue resolution of H/D exchange reactions on a routine basis.

Neutron crystallography

Hydrogen–deuterium exchange of fast-exchanging species can be measured at atomic resolution quantitatively by neutron crystallography, and in real time if exchange is conducted during the diffraction experiment.
High intensity neutron beams are generally generated by spallation at linac particle accelerators such as the Spallation Neutron Source. Neutrons diffract crystals similarly to X-rays and can be used for structural determination. Hydrogen atoms, with between one and zero electrons in a biological setting, diffract X-rays poorly and are effectively invisible under normal experimental conditions. Neutrons scatter from atomic nuclei, and are therefore capable of detecting hydrogen and deuterium atoms.
Hydrogen atoms are routinely replaced with deuterium, which introduce a strong and positive scattering factor. It is often sufficient to replace only the solvent and labile hydrogen atoms in a protein crystal by vapor diffusion. In such a structure the occupancy of an exchangeable deuterium atom in a crystal will refine from 0-100%, directly quantifying the amount of exchange.

Applications

Neutron scattering

Perdeuteration of one component of a multi-component system can provide contrast for neutron scattering experiments, where the contrast obtained by using deuterated solvents is insufficient.

Protein structure

It is not possible to determine the structure of a protein with H/D exchange other than neutron crystallography nor is it possible to define secondary structural elements. The reasons for this are related to the way in which protein structure slows exchange. Exchange rates are a function of two parameters: solvent accessibility and hydrogen bonding. Thus an amide which is part of an intramolecular hydrogen bond will exchange slowly if at all, while an amide on the surface of protein hydrogen bonded to water will exchange rapidly. Amides buried from the solvent but not hydrogen bonded may also have very slow exchange rates. Because both solvent accessibility and hydrogen bonding contribute to the rate of exchange, it becomes difficult to attribute a given exchange rate to a structural element without crystallography or NMR structural data.
H–D exchange has been used to characterize the folding pathway of proteins, by refolding the protein under exchange conditions. In a forward exchange experiment, a pulse of deuterium is added after various amounts of refolding time. The parts of the structure that form rapidly will be protected and thus not exchanged, whereas areas that fold late in the pathway will be exposed to the exchange for longer periods of time. Thus H/D exchange can be used to determine the sequence of various folding events. Factors determining the time resolution of this approach are the efficiency of mixing and how quickly the quench can be performed after the labeling.
H–D exchange has been used to characterize protein structures and protein–protein interactions. The exchange reaction needs to be carried out with the isolated proteins and with the complex. The exchanging regions are then compared. If a region is buried by the binding, the amides in this region may be protected in the complex and exchange slowly. However, one must bear in mind that H–D exchange cannot be used to locate binding interfaces for all protein-protein interactions. Some protein-protein interactions are driven by electrostatic forces of side chains and are unlikely to change the exchange rate of backbone amide hydrogens, particularly if the amide hydrogens are located in stable structural elements such as alpha helices.
Lastly, H–D exchange can be used to monitor conformational changes in proteins as they relate to protein function. If conformation is altered as result of post-translational modification, enzyme activation, drug binding or other functional events, there will likely be a change to H/D exchange that can be detected.