Direct Internet Message Encapsulation was a Microsoft-proposed internet standard in the early 2000s for the streaming of binary and other encapsulated data over the Internet. According to the IETFweb site, the standard has been withdrawn and never made RFC status. However, Microsoft did at one time recommend DIME for transmitting files via Web services. It was also used in Java EE, but differences in the implementation of the protocol made it difficult. The first version was submitted to the IETF in November 2001; the last update was submitted in June 2002. By December 2003, DIME had lost out, in competition with Message Transmission Optimization Mechanism and SOAP with Attachments. Microsoft now describes DIME as "superseded by the SOAP Message TransmissionOptimization Mechanism specification" The standard was intended to be an improved version of MIME. In particular a difficulty with MIME is that each message must be encoded as text and that its sections are separated by a separator given in the message header. This means the entire stream of data must be known to the sender before starting the communication, so as to choose a separator that does not occur in the data. This is not useful if the entire stream is not available when the communication is initiated, or when searching it is expensive. DIME is more oriented to streaming, allowing, for example, a receiver to process chunks of the message as they arrive without having to wait for the entire message.
DIME was defined the transmission format at the data link layer in the OSI model although it was typically transmitted over HTTP. One difficulty here was that it could form an HTTP message of, essentially, any size. Many HTTP receivers were unused to messages as large as this, and if they buffered messages would simply fail, expecting a short message and receiving a huge one. Moreover, if the HTTP receiver was secured, it would, on receiving the message, send back a challenge message to the sender. Because HTTP is connectionless, it would then entirely lose the possibly huge amount of data that had been sent to it, just to accept or deny the challenge. There was no entirely satisfactory solution to this. The response to the challenge could of course succeed, at the expense of sending the data twice, which if it were huge rather defeats its point. In the alternate, and probably better solution, the criteria for a successful challenge is established out-of-band, so it can be sent with the message the first time and not receive a challenge. DIME was extremely fast compared to practical applications of other protocols. Because the data was binary rather than, say, Base64 encoded, it was relatively compact, and the chunking and packet methods built into the protocol meant it could be streamed and read by a suitable receiver before the whole message had been read.
Because DIME was defined at the data link layer, it was possible to encapsulate a DIME message in another DIME message. This would not help at all for compression purposes, but was occasionally useful to bypass networking infrastructure such as routers at the network layer of the OS model, that would otherwise block the encapsulated traffic. That being said, other protocols such as MIME may equally suffer such. Since DIME was generally used between well-trusted clients, a specific port could be opened at the router for the express purpose of sending and receiving DIME traffic. This did not subvert the security aspects, since the challenge would still occur, merely that it accepted that binary traffic was the norm on that port, and not give numerous false positives.
