Curtiss XP-22 Hawk


The Curtiss XP-22 Hawk was a 1930s American experimental biplane fighter built by Curtiss for evaluation by the United States Army Air Service.

Design and development

In 1929, the AAC ordered three P-11 Hawks for testing of the 600 hp H-1640 Chieftain engine. This engine proved a failure, and before completion, one of the three was converted to use a 9-cylinder 575 hp Cyclone, being completed as the YP-20. Testing with the R-1820 was prolonged, so the Army acquired another of the three P-11s, instead. This became the XP-22.
A number of changes were made for installing the 700 hp Curtiss V-1570 Conqueror engine. The radiator was relocated, a new cowl was fitted, and the tail was given more fin and less rudder area, and featured a steerable tailwheel, rather than the original skid. For these changes, Curtiss charged only US$1.
During testing, the XP-22 underwent a number of alterations and improvements, including a change from a three-strut landing gear to a single streamlined strut, later fitted with wheel pants. Fillets were added where struts joined the wing and the tail was briefly reduced in area, to P-6 standard. The XP-22 was also the Army's first fighter capable of 200 mph, achieving 202 mph.

Operational history

In June 1931, the AAC held a competition to evaluate the P-6, P-12, YP-20, and XP-22. The XP-22 came out the winner, earning a contract for 45 aircraft as the Y1P-22. Following the trials, the XP-22 donated a nose and landing gear graft to the YP-20, which became the XP-6E, and the 45 production aircraft were completed to this standard.

Operators