Communications and networking riser is a slot found on certain PC motherboards and used for specialized networking, audio, and telephony equipment. A motherboard manufacturer can choose to provide audio, networking, or modemfunctionality in any combination on a CNR card. CNR slots were once commonly found on Pentium 4-class motherboards, but have since been phased out in favor of on-board or embedded components.
Technology
Physically, a CNR slot has two rows of 30 pins, with two possible pin configurations: Type A and Type B, each with different pin assignments. CNR Type A uses 8-pin PHY interface, while Type B uses 17-pin media-independent interface bus LAN interface. Both types carry USB and AC'97signals. As with AMR, CNR had the cost savings potential for manufacturers by removing analog I/O components from the motherboard. This allowed the manufacturer to only certify with the US Federal Communications Commission for the CNR card, and not the entire motherboard. This resulted in a quicker production-to-market time for new motherboards, and allowed mass-production of CNR cards to be used on multiple motherboards. The ACR slot was a competing specification developed by a group of third-party vendors. Its principal advantage over CNR was the backwards-compatible slot layout which allowed it to use both AMR and ACR cards. The same group also developed a physically smallerversion, the MDC.
History
developed the CNR slot to replace its own audio/modem riser technology, drawing on two distinct advantages over the AMR slot it replaced; CNR was both capable of being either software based or hardware accelerated, and was plug-and-play compatible. On some motherboards, a CNR slot replaced the last PCI slot, but most motherboard manufacturers engineeredboards which allow the CNR and last PCI slot to share the same space. With the integration of components such as ethernet and audio into the motherboard, the CNR is obsolete, and is not found on PC motherboards anymore.
