The bezel is a wider, and usually thicker, section of the hoop of a ring, which may contain a flatsurface, or a gem. The ring is normally worn to display the bezel on the upper or outer side of the finger. The word may also refer to a bezel setting for a stone, which is a general term for a setting holding the stone in place using a raised surrounding for the stone with a lip encircling and overlapping the edges of the stone, thus holding it in place. Modern bezel settings typically use a band of metal containing a groove and a flange to hold a watch crystal or gemstone in its setting. This was the earliest method of setting gemstones into jewelry. In historic examples, such rings were often made by leaving a hole or slot in the ring with a thin lip which was bent over once the stone was inserted, holding it in place. An extension of the word used in this sense can refer to a rotatable rim on a clock or watch used to indicate certain data such as elapsed time. Other types of bezels, less used in modern jewelry, are "swivel bezels" where the bezel, perhaps just formed of a stone with a metal rod through it, can rotate, and "box bezels", where a "box" or cage forms the bezel, often sitting on the main ring hoop, and perhaps open at the top where there is a stone. In gem-cutting the term bezel is used for the sloping faces of a cut stone surrounding a flat "table" face. More broadly, bezels are found on tools and appliances. The sloping face of a chisel is known as a bezel. In vehicles, it is the part of the vehicle's bodywork that surrounds a headlight or turn signal. On a cell phone, it is the back surface that frames the LCD screen.
In making a typical modern bezel setting, the bezel is shaped into the size and shape of the gem and then soldered into place on the metal of the jewelry. The prepared stone is then placed into the bezel and the metal is pressed down over the edges of stone, locking it into place. A cabochon stone, a gemstone that is not faceted, usually relies on the shallow angle cut into the side of the stone, which helps the metal to stay in place. With a clear faceted stone, such as a diamond, a shallow groove is cut into the bezel itself. The girdle, or widest part of the gem stone, is placed in the bezel, which is then pushed down over the girdle. The pressure of the bezel over the edge of the diamond keeps it in place. Bezel settings for diamond rings are also called rub-over settings; they have a diamond completely surrounded by a precious metal band which fastens the diamond securely into place. Bezel settings use a type of elevated collar which wraps the rim of the diamond in a complete metal edging. This type of diamond ring setting is the most secure fastener for the stones. The bezel setting also protects the diamond better than other types of settings, such as the prong setting. A flush setting for diamond rings is a variation on the rub-over or bezel setting. In the flush setting, the stone is placed into an opening and affixed at the bottom of the stone. The top of the diamond is extended above the base.
Advantages
One advantage of the bezel setting, as compared to the prong setting, is that the diamond is better protected from accidental rubbing or blows, and is less likely to allow the diamond to scratch whatever it may come into contact with. The bezel setting is also more secure, so the diamond is less likely to be dislodged.
